Burned leaf edges, stunted growth and plants wilting in moist pots usually mean too much salt in the root zone. EC (electrical conductivity) measures dissolved salts, and fertilizer, acid and the minerals in your water all add to it (e-GRO Alert 10.08; Alert 7.33). The usual causes are too much fertilizer or salty irrigation water (e-GRO 10.08). Confirm it with a substrate EC test, then leach with clear water: a few clear waterings if the EC has been rising test after test, two back-to-back if it is far above your crop's range (e-GRO 7.02). The opposite problem, EC too low after rain or heavy misting, stalls growth and yellows the leaves (e-GRO 7.02, 15.30).
How to tell it is salt
- Too much fertilizer burns the leaf margins (e-GRO 7.02). As salt stress builds, plants are stunted and wilt even when the substrate is moist; on stevia, dark spots between the veins came first, then wilting, then dead leaves (e-GRO 10.08).
- Sodium and chloride from the water build up in the older, mature leaves, so the lower leaves burn and die first and the plants are stunted (e-GRO 7.33).
- Confirm with a substrate EC test. On a PourThru test, e-GRO calls anything above 6.0 mS/cm a problem for many plants; most crops' normal ranges sit well below that, so check yours (e-GRO 7.02, 10.08). Subirrigated pots are the exception to the PourThru, explained below. Compare a reading only with targets for the same method. The same pot gives a higher number by PourThru than by a 1:2 dilution, so the same reading means different things: 1.0 mS/cm is very low by PourThru, while 1.26 or more by 1:2 is already high. Most labs use a third method, the saturated media extract, so read a lab report against its own ranges (e-GRO 6.37). The Crop pH and EC Lookup gives ranges by crop.
- Check the pH too. High substrate EC tends to pull pH down, and low EC lets it rise (e-GRO 6.40).
Where the salt comes from
- Too much fertilizer, one of the two usual causes (e-GRO 10.08). A potassium bicarbonate drench to raise pH also spikes the EC and needs a leach the next day (e-GRO 7.02).
- Salty irrigation water. Near the coast, seawater can get into aquifers; in the north, road de-icing salt seeps into groundwater and shows up in spring; and in farm country, fertilizer leached into groundwater can build up, boron especially (e-GRO 7.33).
- Irrigation that never leaches. Flood floors and subirrigation benches carry no water through the pot, so salts accumulate faster (e-GRO 7.33). In subirrigated pots the salt collects in the top layer, where it is mostly out of the roots' reach, and a PourThru can wash it down into the sample and give a misleading reading (e-GRO 6.37).
- Drying down. As the substrate dries between waterings, water leaves and the salts stay, so the solution around the roots gets saltier than what you fed. The pore-water EC page explains why.
How to bring it down
- If the EC has been rising test after test, give a few clear-water irrigations to flush the salts out (e-GRO 7.02).
- If it is far above your crop's range, such as over 6.0 mS/cm by PourThru, leach twice with back-to-back clear-water irrigations, let the substrate dry down normally, and retest. Still too high? Repeat the double leach (e-GRO 7.02). Running through about 1.5 times what the container holds flushes the substrate; for a pot that holds 1 quart, that is 1.5 quarts out the bottom (e-GRO 7.33).
- Then feed again. Clear water washes nutrients out as well as salts, so once the EC is back in range, go back to a balanced fertilizer at 150 to 200 ppm nitrogen, the rate e-GRO gives for container crops after a leach, then return to your crop's usual program (e-GRO 7.02, 7.33).
If the water is the problem
Risk of toxicity rises when the irrigation water carries 110 ppm chloride or 40 ppm sodium, though the real threshold depends on the crop, how much you leach, and how much calcium and magnesium are present (e-GRO 7.33). Two growers near a highway in the north found 240 ppm chloride and 90 ppm sodium from road salt; heavy leaching saved part of the crop, and spring snowmelt and rain later brought the levels back down (e-GRO 7.33).
- Switch water sources if you can. A new or deeper well is no guarantee, and municipal water or reverse osmosis can be costly or unavailable (e-GRO 7.33).
- Otherwise, leach more: raise the leaching fraction above the usual 20% at each watering, and raise the fertilizer rate to make up for what washes out (e-GRO 7.33).
When the EC is too low
Too little salt is a problem too. Heavy rain on outdoor containers, or heavy mist in propagation, can wash the fertilizer out, leaving plants wet but underfed (e-GRO 15.30, 6.40). Growth stalls and leaves yellow, often the lower leaves first, and garden mums can bud early (e-GRO 7.02, 15.30). To correct it, raise the feed to 300 ppm nitrogen for a few applications, then return to the crop's normal rate (e-GRO 7.02). A low EC during fast growth can simply mean the plants are using the feed; a low or falling EC after days of rain more likely means it has washed out, so test more often after rain and follow the trend, not one reading (e-GRO 15.30).
How to stay in range
- Test your water at a commercial lab at least twice a year for pH, EC, alkalinity, nutrients, sodium, chloride and fluoride, and check its EC in-house between lab tests; a change can signal a change in the water (e-GRO 7.33). Know the water's own EC before you add fertilizer to it (e-GRO 10.08).
- Test the substrate weekly on your key crops, with the same method and the same person each time, meters calibrated weekly, and records kept (e-GRO 6.37). Check new bags of mix straight out of the bag too (e-GRO 6.37).
- Leach a little at each watering where your system allows; the usual recommendation is a leaching fraction of about 20% (e-GRO 7.33). The Fertilizer Injector Calculator helps keep the feed at the rate you meant.
Extension alerts on EC and salts
Short alerts on EC and salts from university greenhouse specialists, published through e-GRO. The 6 newest below; each opens the alert itself on e-gro.org.
Search every e-GRO alert on EC and salts in Greenhouse Alerts, indexed by crop and problem.
Tools and related pages
Sources
- Whipker, B.E., J. Henry and W.G. Owen. 2018. Corrective Procedures for Modifying Substrate pH and Electrical Conductivity (EC). e-GRO Alert 7.02 (NC State). High and low EC corrections.
- Veazie, P., P. Cockson and B.E. Whipker. 2021. Stevia: Managing EC to Prevent Foliar Damage. e-GRO Alert 10.08 (NC State). Symptoms and causes of high EC.
- Dickson, R. 2018. Dealing with Salty Irrigation Water. e-GRO Alert 7.33. Sodium and chloride, thresholds, leaching and water testing.
- Cabrera, J. and R. Raudales. 2017. Monitoring pH and EC of Growing Medium. e-GRO Alert 6.37 (UConn). Methods, comparing results, monitoring.
- Dickson, R. 2017. High pH Caused by Excessive Leaching. e-GRO Alert 6.40. How substrate EC and pH move together.
- Owen, W.G. 2026. When Rain Washes Out the Feed in Outdoor Mum Production. e-GRO Alert 15.30 (Ohio State). Low EC after rain.
Frequently asked questions.
What are the symptoms of high EC in plants?
Burned leaf edges, stunted growth, and wilting even when the substrate is moist, followed by dead leaves. When sodium or chloride from the water is the cause, the lower, older leaves burn first. Confirm with a substrate EC test (e-GRO Alerts 7.02, 10.08 and 7.33).
What EC is too high for plants?
By the PourThru method, an EC above 6.0 mS/cm is a problem for many plants. Compare readings only with targets for the same method: a 1:2 dilution reads lower than a PourThru on the same pot, and ranges differ by crop (e-GRO Alerts 7.02 and 6.37).
How do I lower the EC in my pots?
If it is just starting to climb, give a few clear-water irrigations. If it is well over, leach twice back to back with clear water, let the substrate dry down, retest, and repeat if needed. Then resume a balanced fertilizer at 150 to 200 ppm nitrogen, since leaching washes out nutrients too (e-GRO Alert 7.02).
How much water does it take to leach salts from a pot?
About 1.5 times the volume of water the container holds should drain out the bottom. For a pot that holds 1 quart, apply enough that 1.5 quarts leach through (e-GRO Alert 7.33).
How much sodium and chloride in irrigation water is too much?
Toxicity risk rises from about 110 ppm chloride and 40 ppm sodium in the water, though the real limit depends on the crop, how much you leach, and the calcium and magnesium present. A lab water test shows both (e-GRO Alert 7.33).
What causes low EC in container plants?
Fertilizer washed out by heavy or repeated rain, heavy mist in propagation, or too little feed. Growth stalls and lower leaves yellow. Raise the feed to 300 ppm nitrogen for a few applications, then return to the normal rate (e-GRO Alerts 15.30, 6.40 and 7.02).
Why is EC higher in subirrigated or flood-floor crops?
Those systems never run water through the pot, so salts are not leached and build up. Much of it collects in the top layer of the pot, where a PourThru can wash it down into the sample and give a misleading reading (e-GRO Alerts 7.33 and 6.37).
Does high EC affect substrate pH?
Yes. A high substrate EC, for example from excess fertilizer, tends to lower the pH, and a low EC from heavy leaching tends to raise it. Check both at once (e-GRO Alert 6.40).