Pythium root rot shows first as plants that look nutrient-deficient: stunted, yellowing, or wilting in the brightest part of the day. Pull one and the roots are brown and soft, with few fine roots, and the outer layer slips off to leave a bare inner core, the "rat tail" that marks Pythium. It is a water mold that lives in soil and water and attacks roots already stressed by too much water, too much fertilizer or too little oxygen. Once plants are infected it is hard to control, so the work is removing the sick plants, fixing the conditions that let it in, and cleaning up so it does not come back (e-GRO Alerts 6.08 and 7.06; Food Crops 3.01).
How to tell it is Pythium
- Above ground: plants look nutrient-deficient, yellow or stunted, and wilt first in the hottest, brightest hours, then for good. There may be stem or crown rot or dying lower leaves (e-GRO 6.08; Food Crops 3.01).
- The roots: poorly developed, brown and rotted, with brown lesions at the root tips, few lateral roots or root hairs, and in the end slimy and black. The outer root layer pulls off and leaves the inner core bare, the "rat tail" (e-GRO 6.08; Food Crops 1.04, 3.01).
- Sometimes almost nothing: in a Connecticut trial, hydroponic lettuce infected with Pythium looked marketable but weighed 24 grams less on average than healthy plants (e-GRO Food Crops 1.04).
Always compare with the roots of a healthy plant of the same crop. Root rots are hard to tell apart by eye, so send a sample to a diagnostic lab: a fungicide labeled for Pythium will not necessarily control another root rot (e-GRO 6.08).
In containers: what to do
- Pull the plants with rotted roots now, send one or two to a plant diagnostic lab, and hold off on a fungicide until you know which root rot it is, since a product for Pythium may not control another (e-GRO 6.08).
- Water less, and to the weather. Pythium takes hold when the substrate stays too wet for too long, which is easiest to do in cold, cloudy spells. Irrigate for current and coming conditions, not by the calendar (e-GRO 6.08).
- Do not overfeed. Too high a fertilizer rate can make root rot much worse (e-GRO 6.08). In one Cornell demonstration, Pythium-inoculated snapdragons fed 350 ppm N rotted far worse than those fed 200 ppm N. If a PourThru test reads above your crop's EC range, bring it down with a few clear-water irrigations (e-GRO 7.02).
- Get the basics right next time: well-drained growing media, no planting too deep, good-quality plant material, and conditions that suit the crop (e-GRO 6.08).
- Never reuse rooting mix or put floor sweepings back into it, and disinfect benches and equipment between crops (e-GRO Food Crops 7.06).
In hydroponics: what to do
- Pull infected plants as soon as symptoms show. Infected roots release swimming spores into the water continuously, and they spread through a recirculating system fast (e-GRO Food Crops 7.06).
- Check the water temperature and oxygen. Hold the root zone at 68 to 75°F (20 to 24°C) and dissolved oxygen above 6 ppm, ideally saturated at 8 to 9 ppm. Warmer water favors Pythium aphanidermatum and cooler water P. dissotocum, so cooling alone is not a cure: at Cornell, chilling spinach ponds to about 68°F reduced P. aphanidermatum without eliminating it (e-GRO Food Crops 3.01).
- Treat the recirculating water. Shared systems are rarely drained, so they need disinfection: filtration to clear organic matter and algae, then UV, which only works on clear water (e-GRO Food Crops 7.06).
- Clean or replace the rafts. Polystyrene rafts are porous; roots grow into the pores and carry the pathogen to the next crop. Wash off debris and heat-treat or disinfect them, or switch to plastic rafts, which are easier to clean (e-GRO Food Crops 7.06).
- Control algae, fungus gnats and shore flies. The insects eat spores on rotting roots and spread them in their droppings (e-GRO Food Crops 7.06).
- Start every cycle clean. Remove old plant material and media, scrub or pressure-wash organic matter off surfaces before any sanitizer, then rinse the sanitizer off (e-GRO Food Crops 1.04). Keep the seeding area cleanest of all (e-GRO Food Crops 7.06).
Why it takes hold
Pythium is everywhere soil and water meet: retention ponds, streams, soil carried in on shoes, tools and equipment. Most species are harmless, but a few, among them P. aphanidermatum, P. ultimum and P. irregulare, are serious crop pathogens. Its spores swim through water toward damaged root tips, which is why roots already hurt by low oxygen or high EC are the ones it takes (e-GRO Food Crops 7.06). Waterlogged substrate, high fertility, low dissolved oxygen, extreme temperatures and physical injury to roots, including letting them dry out, all open the door (e-GRO Food Crops 3.01). Clean well water is the safest source for a hydroponic system, since it is unlikely to carry Pythium (e-GRO Food Crops 7.06).
Low-pH suppression in NFT and DWC
In liquid hydroponic systems, running the nutrient solution at pH 4.0 to 4.5 suppresses Pythium, in part because low pH hampers the swimming spores. In Ohio State trials, basil roots inoculated at pH 4.0 stayed healthy while those at 5.5 rotted, and a lettuce pond outbreak was held back at pH 4.0 (e-GRO Food Crops 11.05, Kubota 2026). The cautions from the same work:
- It suppresses, it does not eradicate: when the pond went back to pH 5.5, symptoms came back.
- It suits nutrient film and deep water culture, not substrate-based systems.
- Materials in contact with acidic solution can release metals: Batavia lettuce showed toxicity, with high iron and aluminum, within six days at pH 4.0, while butterhead and romaine did not. Check substrates with suppliers and run a small trial first.
- Plants may need a stronger feed to make up for reduced nutrient uptake.
Look-alikes
- Black root rot (Berkeleyomyces, formerly Thielaviopsis) also darkens roots; a lab separates them (e-GRO Food Crops 7.06).
- Salt injury from a high EC burns leaf margins (e-GRO 7.02) and damages the root tips Pythium goes for (e-GRO Food Crops 7.06). A PourThru test tells you which way the EC is running.
- Nutrient deficiency: the yellowing of Pythium is often mistaken for it; look at the roots before changing the feed (e-GRO Food Crops 3.01).
- Warm, oxygen-poor solution in hydroponics injures roots by itself and favors Pythium; see why roots turn brown and rot.
Extension alerts on Pythium and other root rots
Short alerts on Pythium and other root rots from university greenhouse specialists, published through e-GRO. The 6 newest below; each opens the alert itself on e-gro.org.
Search every e-GRO alert on Pythium and other root rots in Greenhouse Alerts, indexed by crop and problem.
Tools and related pages
Sources
- Williams-Woodward, J. 2022. Root Disease Management in Hydroponic Systems. e-GRO Food Crops Alert 7.06 (University of Georgia). Biology, sources, rafts, aeration and temperature, insects, water treatment, seeding area.
- Mattson, N. 2018. Pythium Root Rot on Hydroponically Grown Basil and Spinach. e-GRO Food Crops Alert 3.01 (Cornell). Symptoms, predisposing conditions, root-zone temperature and dissolved oxygen targets, the chiller result.
- Raudales, R.E. and C. McGehee. 2016. Pythium Root Rot on Hydroponic Lettuce. e-GRO Food Crops Alert 1.04 (UConn). Symptoms, the yield loss without visible symptoms, starting clean.
- Catlin, N. 2017. Pythium Problems. e-GRO Alert 6.08 (Cornell). Container symptoms, diagnosis, overwatering and the fertilizer demonstration.
- Whipker, B.E., J. Henry and W.G. Owen. 2018. Corrective Procedures for Modifying Substrate pH and Electrical Conductivity (EC). e-GRO Alert 7.02. Lowering a high EC; high EC and leaf burn.
- Kubota, C. 2026. Considerations for Lowering pH to Suppress Root Rot Diseases in Hydroponics. e-GRO Food Crops Alert 11.05 (Ohio State).
Frequently asked questions.
What does Pythium root rot look like?
Above ground, plants look nutrient-deficient: stunted, yellow, and wilting in the brightest part of the day. The roots are brown and soft with few fine roots, and the outer layer slips off to leave a bare inner core, called a rat tail. Later the roots turn slimy and black (e-GRO Alert 6.08; Food Crops Alerts 1.04 and 3.01).
What causes Pythium root rot?
Pythium, a water mold that lives in soil and water, enters roots already stressed by waterlogged substrate, too much fertilizer, low dissolved oxygen, extreme temperatures or injury. Its spores swim through water to damaged root tips (e-GRO Food Crops Alerts 3.01 and 7.06).
Is Pythium a fungus?
No. Pythium is a water mold, an oomycete, which is why it spreads so well in water: it makes spores that swim toward roots. That also means a product labeled for a fungal root rot may not control it, so confirm the diagnosis first (e-GRO Food Crops Alert 7.06; Alert 6.08).
How do I get rid of Pythium in hydroponics?
Pull infected plants as soon as symptoms show, hold the water at 68 to 75 F with dissolved oxygen above 6 ppm, disinfect recirculating water with filtration and UV, clean or replace porous rafts, control algae, fungus gnats and shore flies, and start every cycle with a cleaned system. In NFT and DWC, a nutrient solution at pH 4.0 to 4.5 can suppress it (e-GRO Food Crops Alerts 3.01, 7.06 and 11.05).
What water temperature prevents Pythium in hydroponics?
There is no single safe temperature. Cornell targets a root zone of 68 to 75 F (20 to 24 C); warmer water favors Pythium aphanidermatum and cooler water Pythium dissotocum. Chilling ponds to about 68 F reduced P. aphanidermatum on spinach at Cornell but did not eliminate it (e-GRO Food Crops Alert 3.01).
Can plants recover from Pythium root rot?
Pythium is hard to control once symptoms appear, and infected roots keep releasing spores that spread to healthy plants. The extension advice is to discard infected plants as soon as symptoms show and protect the rest by fixing the water, the feed and the sanitation (e-GRO Food Crops Alerts 1.04 and 7.06).
Does lowering the pH stop Pythium?
In liquid systems such as NFT and deep water culture, a nutrient solution at pH 4.0 to 4.5 suppressed Pythium in Ohio State trials, but symptoms returned when the pH went back to 5.5. It is not for substrate-based systems, some lettuce types and materials react badly at pH 4, and a small trial should come first (e-GRO Food Crops Alert 11.05).
Does overwatering cause root rot?
Overwatering does not create Pythium, which has to be present already, but substrate that stays too wet for too long is the condition it needs to take hold. Water to the weather, especially in cold, cloudy spells, and use a well-drained mix (e-GRO Alert 6.08).